Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge T130 Owner's Manual

Installing the control panel assembly

Prerequisites

CAUTION Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Ensure that you follow the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the bezel.
  4. Keep the Phillips #2 screwdriver ready.

Steps

  1. Insert the control panel assembly into the guide slot and slide it downward to lock the assembly into place.
  2. To secure the control panel, insert and tighten the screws to the chassis.
  3. Route the control panel and USB data cables through the chassis clip.
  4. Connect the control panel and USB data cables to the system board.
    Figure 1. Installing the control panel assembly
    The figure shows installing the control panel assembly.
    1. screw (3)
    2. control panel assembly
    3. control panel assembly guide (2)
    4. control panel assembly guide slot (2)

Next steps

  1. Install the bezel.
  2. Reconnect the disconnected peripherals from the control panel assembly.
  3. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\