Your system supports up to two –(48–60) V DC
power supply units (PSUs).
Input requirements
NOTE For equipment using
–(48–60) V DC power supply units (PSUs), a qualified electrician must
perform all connections to DC power and to safety grounds. Do not
attempt connecting to DC power or installing grounds yourself. All
electrical wiring must comply with applicable local or national codes
and practices. Damage due to servicing that is not authorized by Dell
is not covered by your warranty. Read and follow all safety instructions
that came with the product.
CAUTION Wire
the unit with copper only, unless otherwise specified, use only 10
American Wire Gauge (AWG) wire rated minimum 90ºC for source and return.
Protect the –(48–60) V DC (1 wire) with a branch circuit over-current
protection rated 50 A for DC with a high interrupt current rating.
CAUTION Connect the equipment to a –(48–60) V DC supply source
that is electrically isolated from the AC source (reliably grounded
–(48–60) V DC SELV source). Ensure that the –(48–60) V DC source is
efficiently secured to earth (ground).
NOTE A readily accessible
disconnect device that is suitably approved and rated shall be incorporated
in the field wiring.
Supply voltage:
–(48–60) V DC
Current
consumption: 32 A (maximum)
Kit contents
Dell part
number 6RYJ9 terminal block or equivalent (1)
#6-32 nut
equipped with lock washer (1)
Required tools
Wire-stripper pliers capable of removing insulation
from size 10 AWG solid or stranded, insulated copper wire.
NOTE Use alpha wire part
number 3080 or equivalent (65/30 stranding).
Required wires
One UL 10
AWG, 2 m maximum (stranded) black wire [–(48–60) V DC].
One UL 10
AWG, 2 m maximum (stranded) red wire (V DC return).
One UL 10
AWG, 2 m maximum, green with a yellow stripe, stranded wire (safety
ground).
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\