Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge R760 Installation and Service Manual

PDF

Installing the EDSFF E3.S rear drive module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the cooling fan cage assembly.
  4. Remove the air shroud.
  5. Remove the expansion card riser 1.
  6. Remove an EDSFF E3. S drive carrier.
  7. Disconnect the rear drive cables from the system board.
    NOTE:See cable routing section for more information.

Steps

  1. Align the slot on the rear drive module with the guide on the system.
  2. Lower and press the rear drive module on top of the riser until firmly seated.
  3. Using a Phillips #2 screwdriver, tighten the captive screw that secures the rear drive module into the system.
    Figure 1. Installing the EDSFF E3.S rear drive module
    This image shows Installing the EDSFF rear drive module

Next steps

  1. Connect and route all the cables from the rear drive module.
  2. Install an EDSFF E3.S drive carrier.
  3. Install the expansion card riser 1.
  4. Install the air shroud.
  5. Install the cooling fan cage assembly.
  6. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\