Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge R760 Installation and Service Manual

PDF

Installing an EDSFF E3.S drive carrier

Prerequisites

CAUTION:Before removing or installing a drive while the system is running, see the www.dell.com/storagecontrollermanuals documentation for the storage controller card to ensure that the host adapter is configured correctly to support drive removal and insertion.
CAUTION:Combining SAS and SATA drives in the same RAID volume is not supported.
CAUTION:When installing a drive, ensure that the adjacent drives are fully installed. Inserting a drive carrier and attempting to lock its handle next to a partially installed carrier can damage the partially installed carrier's shield spring and make it unusable.
NOTE:Ensure that the drive carrier's release handle is in the open position before inserting the carrier into the slot.
CAUTION:To prevent data loss, ensure that your operating system supports hot-swap drive installation. See the documentation supplied with your operating system.
CAUTION:When a replacement hot swappable drive is installed and the system is powered on, the drive automatically begins to rebuild. Ensure that the replacement drive is blank or contains data that you wish to overwrite. Any data on the replacement drive is immediately lost after the drive is installed.
  1. Follow the safety guidelines listed in Safety instructions.
  2. Remove the front bezel.
  3. Remove the drive carrier or remove the drive blank when you want to assemble the drive into the system.

Steps

  1. Slide the drive carrier into the drive slot and push until the drive connects with the backplane.
  2. Close the drive carrier release handle to lock the drive in place.
    Figure 1. Installing an EDSFF E3.S drive carrier
    This image shows installing an EDSFF E3.S drive blank

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\