Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge R760 Installation and Service Manual

PDF

Removing the side wall bracket

There are two side wall brackets on either side of the system. The procedure to remove is similar.

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. If required, remove the drive backplane cover.
  4. If installed, remove the air shroudor remove the GPU air shroud.
  5. Remove the cooling fan cage assembly.
NOTE:Ensure that you note the routing of the cables as you remove them from the system board. Route the cables properly when you replace them to prevent the cables from being pinched or crimped.

Steps

  1. Press the blue side tabs to release the side wall cable holder.
    NOTE:Move the cables out of the side wall cable holder.
  2. Press the center tab to release the bracket from the chassis, and lift it away from the system.
    Figure 1. Removing the side wall bracket
    This image shows Removing the side wall bracket.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\