Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge R760 Installation and Service Manual

PDF

Removing the processor

Prerequisites

WARNING:Remove the processor from processor and heat sink module (PHM) only if you are replacing the processor or heat sink.
  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the air shroud or remove the GPU air shroud.
  4. Remove the processor heat sink module.
CAUTION:You may find the CMOS battery loss or CMOS checksum error that is displayed during the first instance of powering on the system after the processor or system board replacement which is expected. To fix this, simply go to setup option to configure the system settings.

Steps

  1. Place the heat sink with the processor side facing up.
  2. Using your thumb, lift the thermal interface material (TIM) break lever to release the processor from the TIM and retaining clip.
    NOTE:For Xeon Max processor, turn the side lever (up to 60 degrees) with the flat blade screwdriver to release the Xeon Max processor from the TIM and retaining clip.
  3. Holding the processor by the edges, lift the processor away from the retaining clip.
    NOTE:Ensure to hold the retaining clip to the heat sink as you lift the TIM break lever.
    Figure 1. Removing the processor
    This image shows removing the processor
    Figure 2. Removing the Xeon Max processor
    This image shows removing the processor
    NOTE:Ensure to return the TIM break lever or side lever on the retaining clip back to original position.
  4. Using your thumb and index finger, first hold the retaining clip release tab at the pin 1 connector, pull out the tip of the retaining clip release tab, and then lift the retaining clip partially from the heat sink.
  5. Repeat the procedure at the remaining three corners of the retaining clip.
  6. After all the corners are released from the heat sink, lift the retaining clip from the pin 1 corner of the heat sink.
    Figure 3. Removing the retaining clip
    This image shows Removing the retaining clip
    Figure 4. Removing the Xeon Max retaining clip
    This image shows Removing the retaining clip

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\