Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R7415 Installation and Service Manual

PDF

Installing the mini PERC card

Prerequisites

Follow the safety guidelines listed in Safety instructions.

Steps

  1. Slide the mini PERC card at an angle into the card holder on the system board.
  2. Lower the mini PERC card into place until the mini PERC card is firmly seated on the card holder.
  3. Route the cable along the side walls of the chassis.
  4. Align the screws on the cable with the screw holes on the mini PERC card.
  5. Using a Phillips #2 screwdriver, secure the cable to the mini PERC card with the screws.
    Figure 1. Installing the mini PERC card
    This image shows installing the mini PERC card

Next steps

  1. If removed, install the riser 1B.
  2. Install the air shroud.
  3. If removed, install the rear drive cage.
  4. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\