Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R740xd2 Installation and Service Manual

PDF

Removing bay intrusion switch

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. If installed, remove the front bezel.
  4. Open the drive bays.
  5. Remove the drive bay 1 bracket.

Steps

  1. Disconnect the intrusion switch cable connected to the backplane of drive bay 1.
  2. Using a Phillips #1 screwdriver, remove the screws securing the intrusion switch to the intrusion switch slot.
  3. Disengage the intrusion switch from the intrusion switch slot and remove it from the system.
    Figure 1. Removing the bay intrusion switch
    This image shows how to remove the bay intrusion switch.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\