- Notes, cautions, and warnings
- About this document
- Dell Technologies PowerEdge R740xd2 system overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Front bezel
- System cover
- Air shroud
- Internal PERC riser
- Cooling fans
- Intrusion switch
- Drive bay
- Drives
- Removing a drive blank
- Installing a drive blank
- Removing a drive carrier
- Removing the drive from the drive carrier
- Installing a drive carrier
- Installing a drive into the drive carrier
- Removing a 2.5-inch drive from a 3.5-inch drive adapter
- Installing a 2.5-inch drive into a 3.5-inch drive adapter
- Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier
- Installing a 3.5-inch drive adapter into the 3.5-inch drive carrier
- Drive backplane bracket
- Bay intrusion switch
- Rear drive cage
- Drive backplane
- Cable routing
- System memory
- Processor and heat sink
- Expansion cards and expansion card risers
- Expansion card installation guidelines
- Removing expansion card from the system board
- Removing expansion card from the expansion card riser
- Installing expansion card into the expansion card riser
- Installing expansion card on the system board
- Removing an expansion card riser
- Installing an expansion card riser
- M.2 SSD module
- Optional IDSDM / vFlash module
- LOM riser card
- System battery
- Optional internal USB memory key
- Power supply units
- Power interposer board
- System board
- Trusted Platform Module
- Cable chain assembly
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Dell EMC PowerEdge R740xd2 Installation and Service Manual
Opening the drive bays
Prerequisites
CAUTION:Drive bays should not be in service position for more than 5 minutes because of thermal concerns. When the drive bay is open for more than
five minutes, the cooling fans spin at a higher speed to provide
extra cooling to the system. Thus system health status changes from
the normal to critical state, and system event "The BP1 drive bay
is kept open for an extended period of time" is logged.
- Follow the safety guidelines listed in Safety instructions.
- If installed, remove front bezel.
Steps
- If locked, unlock the drive bay lock located above the left release latch, by pushing it up.
- Open the release latches of drive bay 1 and pull the drive bays out.
Figure 1. Opening the drive bays 
Next steps
- If installed, remove a drive blank or install a drive blank.
- If installed, remove a drive carrier or install a drive carrier.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\