Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R740xd Installation and Service Manual

PDF

Removing expansion card riser 2

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. If applicable, close the PCIe card holder latch on the air shroud to release the full length card.
  4. If installed, remove expansion cards installed on the riser.
  5. Remove the air shroud.
  6. Disconnect any cables connected to the riser.

Steps

  1. To remove expansion card riser 2A:
    1. Using Phillips #2 screwdriver, loosen the screws that secure the riser to the system.
    2. Press the release tab, and holding the riser by its edges, lift the riser from the riser connector on the system board.
    Figure 1. Removing expansion card riser 2A
    This image shows removing expansion card riser 2A.
  2. To remove expansion card riser 2B or 2C, hold the riser by its edges and lift the riser from the riser connector on the system board.
    Figure 2. Removing expansion card riser 2
    This image shows removing expansion card riser 2.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\