Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R740 Installation and Service Manual

PDF

Removing the right control panel

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.
  4. Remove the cooling fan assembly.

Steps

  1. Disconnect the VGA cable from the system board.
  2. Pull the cable latch and disconnect the control panel cable from the system board connector.
  3. Using Phillips #1 screwdriver, remove the screws that secure the control panel and cable tube to the system.
  4. Holding the control panel and cable tube by its sides, remove the control panel and cable tube away from the system.
    Figure 1. Removing right control panel
    This image shows removing right control panel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\