Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R740 Installation and Service Manual

PDF

Installing USB 3.0 module

Prerequisites

Follow the safety guidelines listed in Safety instructions.

NOTE:The position of the USB 3.0 module may vary depending on the configuration of your system.

Steps

  1. Route the power and the USB cables on the USB 3.0 module through the USB 3.0 module slot on the front panel.
  2. Insert the USB 3.0 module into the slot on the front panel.
  3. Align the screws on the module with the screw holes on the system.
  4. Using the Phillips #2 screwdriver, tighten the screw to secure the module to the system.
  5. Route and connect the USB cable to internal USB port and power cable to the backplane 3 power connector on the system board.
    To locate the connector, see the System board jumpers and connectors section.
    Figure 1. Installing USB 3.0 module
    This image shows installing USB 3.0 module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\