Depending
on your system configuration, the backplanes supported in PowerEdge
R740 are listed here:
Table 1. Supported backplane
options for PowerEdge R740 systems.This table lists the supported drives supported
options for PowerEdge R730 systems. The options are 2.5 inch (x16)
SAS/SATA backplane, or 2.5 inch (x8) SAS/SATA backplane, or 3.5 inch
(x8) SAS/SATA backplane.
System
Supported backplane options
PowerEdge
R740
2.5 inch (x16) SAS/SATA backplane, or
2.5 inch (x8) SAS/SATA backplane, or
3.5 inch (x8) SAS/SATA backplane
Figure 1. Back view of
16 x 2.5 inch drive backplane
signal connector (J_BP_SIG)
power connector (J_BP_PWR)
Figure 2. Back view of
8 x 2.5 inch drive backplane
SAS connector (BP SAS B)
SAS connector (BP SAS A)
power connector (J_BP_PWR)
signal connector (J_BP_SIG)
Figure 3. Back view of
8 x 3.5 inch drive backplane
SAS connector (BP SAS B)
signal connector (J_BP_SIG)
SAS connector (BP SAS A)
power connector (J_BP_PWR_A)
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
