Table 1. PowerEdgeR6525 system USB specificationsThe following table shows the USB specifications for the
PowerEdgeR6525 system:
Front
Rear
Internal
USB port type
No. of ports
USB port type
No. of ports
USB port type
No. of ports
USB 2.0-compliant port
One
USB 3.0-compliant ports
One
Internal USB 3.0-compliant port
One
Micro-USB 2.0 compliant port
One
USB 2.0-compliant ports
One
NOTE The micro USB 2.0 compliant port can only be used as an iDRAC Direct or a management port.
NOTE The USB 2.0 specifications provide a 5 V supply on a single wire to power connected USB devices. A unit load is defined as 100 mA in USB 2.0, and 150 mA in USB 3.0. A device may draw a maximum of 5 unit loads (500 mA) from a port in USB 2.0; 6 (900 mA) in USB 3.0.
NOTE The USB 2.0 interface can provide power to low-power peripherals but must adhere to USB specification. An external power source is required for higher-power peripherals to function, such as external CD/DVD Drives.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\