The BOSS-S2 Command Line Interface (CLI) Utility enables you to check controller, physical disk, and virtual disk status while booted to an operating system. The application is also used to check physical disks and display controller SMART information. For more information about CLI commands, see
Manage BOSS-S2 using CLI commands.
Table 1. BOSS-S2 CLI utility for supported operating systemsThis table describes the BOSS-S2 CLI utility for supported operating systems.
Operating system
Utility name
Windows
mvsetup
Linux
mvcli
ESXi
mvcli
NOTE:To use the mvsetup Windows utility, the BOSS-S2 management driver must be installed first. You can download the latest Windows unified console driver from
www.dell.com/support/home. Linux or ESXi mvcli does not require a driver.
NOTE:To remove mvcli from the operating systems, uninstall BOSS-S2 drivers from the operating systems or remove the libraries and the executable files.
Table 2. Instructions to remove mvcli from the operating systemsThis table describes the instructions to remove mvcli from operating systems.
Operating system
Instructions to remove mvcli from the operating systems
Windows
Locate and remove the library and executable files
Linux
Locate and remove the library and executable files
ESXi
Remove using
vib remove command
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\