- Notes, cautions, and warnings
- Dell EMC PowerEdge R640 overview
- Documentation resources
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Drives
- Backplane cover
- Inside the system
- Air shroud
- Cooling fans
- System memory
- NVDIMM-N battery
- Processors and heat sinks
- Expansion cards and expansion card risers
- M.2 SSD module
- Optional IDSDM or vFlash module
- Optional IDSDM or vFlash module
- Network daughter card
- Integrated storage controller card
- Backplane
- Cable routing
- SAS expander card
- Rear drive cage
- System battery
- USB module
- VGA module
- Optional internal USB memory key
- Optical drive (optional)
- Power supply units
- System board
- Trusted Platform Module
- Control panel
- System diagnostics
- Jumpers and connectors
- Getting help
Dell EMC PowerEdge R640 Installation and Service Manual
Installing the rear drive cage
Prerequisites
Steps
- Align the screws on the drive cage with the screw holes on the system chassis.
- Lower the drive cage into the system until it is firmly seated and the screws locks into place.
- Using Phillips #2 screwdriver, tighten the
screws.
Figure 1. Installing the rear drive cage 
Next steps
- Reconnect all the disconnected cables to the rear drive backplane.
- Install all the drives.
- Follow the procedure listed in After working inside your system.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\