Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R640 Installation and Service Manual

PDF

Installing the integrated storage controller card

Prerequisites

Follow the safety guidelines listed in Safety instructions.

Steps

  1. Angle the integrated storage controller card and align the end of the card with the controller card connector on the system board.
  2. Lower the connector side of the integrated storage controller card into the integrated storage controller card connector on the system board.
    NOTE:Ensure that the slots on the system board align with the screw holes on the integrated storage controller card connector.
    Figure 1. Installing the integrated storage controller card
    The image shows Installing the integrated storage controller card
  3. Route the integrated storage controller card cable along the wall of the system.
  4. Align the screws on the integrated storage controller card cable with the screw holes on the connector.
  5. Using Phillips #2 screwdriver, tighten the screws to secure the integrated storage controller card cable to the card connector on the system board.
    Figure 2. Installing the integrated storage controller card cable
    The image shows Installing the integrated storage controller card cable

Next steps

  1. Install the air shroud.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\