Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell EMC PowerEdge R550 Installation and Service Manual

Removing the system board

Prerequisites

CAUTION: If you are using the Trusted Platform Module (TPM) with an encryption key, you may be prompted to create a recovery key during program or System Setup. Be sure to create and safely store this recovery key. If you replace this system board, you must supply the recovery key when you restart your system or program before you can access the encrypted data on your drives.
  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the following components:
    1. Air shroud
    2. Cooling fan cage assembly
    3. Expansion cards
    4. IDSDM module (if installed)
    5. Internal USB key (if installed)
    6. Processor and heat sink module
    7. Memory modules
    8. OCP (if installed)
    9. OCP shroud
    10. Disconnect all cables from the system board.
      CAUTION: Take care not to damage the system identification button while removing the system board from the system.

Steps

  1. Using the system board holder and plunger, slide the system board toward the front of the chassis.
  2. By using holder and plunger that is located on system board and lift the system board out of the chassis, leaning at an angle.
    Figure 1. Removing the system board
    This image shows the removal of the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\