To enable communication between your system and iDRAC, you must first configure the network settings based on your network infrastructure. The network settings option is set to
DHCP, by default.
NOTE: For static IP configuration, you must request for the settings at the time of purchase.
You can set up the iDRAC IP address using one of the interfaces in the table below. For information about setting up iDRAC IP address, see the documentation links provided in the table below.
Table 1. Interfaces to set up iDRAC IP addressThis table lists the interfaces to set up the iDRAC IP address.
NOTE: To access iDRAC, ensure that you connect the ethernet cable to the iDRAC dedicated network port or use the iDRAC Direct port by using the USB cable.
You can also access iDRAC through the shared LOM mode, if you have opted for a system that has the shared LOM mode enabled.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\