Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R550 Installation and Service Manual

PDF

Installing the intrusion switch module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.
  4. Disconnect the system power cable from the system board.

Steps

  1. Align and insert the intrusion switch module into the slot on the system until firmly seated.
  2. Using the Phillips #1 screwdriver, tighten the screw securing the intrusion switch module.
  3. Connect the intrusion switch cable to the connector on the system board.
    NOTE: Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
    Figure 1. Installing the intrusion switch
    This image shows how to install the intrusion switch.

Next steps

  1. Connect the system power cable to the system board.
  2. Install the air shroud.
  3. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\