Dell EMC PowerEdge R550 Installation and Service Manual

Installing the BOSS S2 module

Slide the BOSS cover on the BOSS S2 module. Using the Phillips #1 screwdriver, secure the BOSS cover on the BOSS S2 module with the M3 x 0.5 x 4.5 mm screw.
Figure 1. Installing the BOSS cover
Connect the BOSS power cable and BOSS signal cable to the BOSS S2 module.
Figure 2. Connecting the BOSS power cable and BOSS Signal cable to the BOSS S2 module
Slide the BOSS S2 module into the BOSS module bay until it is firmly seated.
Using the Phillips #1 screwdriver, secure the BOSS S2 module on the BOSS module bay with the two M3 x 0.5 x 4.5 mm screws.
Figure 3. Installing the BOSS S2 module
Connect the BOSS power cable to the PIB and the BOSS signal cable to the motherboard.
Figure 4. Connecting the BOSS power cable and signal cable
Align the M.2 SSD at an angle with the BOSS S2 card carrier.
Insert the M.2 SSD until it is firmly seated in the BOSS S2 card carrier.
Using the Phillips #1 screwdriver, secure the M.2 SSD on the BOSS S2 card carrier with the M3 x 0.5 x 4.5 mm screw.
Figure 5. Installing the M.2 SSD
Slide the BOSS S2 card carrier into the BOSS S2 module slot.
Close the BOSS S2 card carrier release latch to lock the carrier in place.
Figure 6. Installing the BOSS S2 card carrier