The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRAC subsystem.
You can configure iDRAC Direct by using a USB to micro USB (type AB) cable, which you can connect to your laptop or tablet. Cable length should not exceed 3 feet (0.91 meters). Performance could be affected by cable quality. The following table describes iDRAC Direct activity when the iDRAC Direct port is active:
Table 1. iDRAC Direct LED indicator codesThe iDRAC Direct LED indicator codes table describes the iDRAC status when it is solid green, blinking green, and when it is powered off.
iDRAC Direct LED indicator code
Condition
Solid green for two seconds
Indicates that the laptop or tablet is connected.
Blinking green (on for two seconds and off for two seconds)
Indicates that the laptop or tablet connected is recognized.
LED Indicator off
Indicates that the laptop or tablet is unplugged.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\