Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R550 Installation and Service Manual

PDF

Removing the intrusion switch module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the air shroud.
  4. Disconnect the system power cable from the system board.

Steps

  1. Disconnect the intrusion switch cable from the connector on the system board.
    NOTE: Observe the routing of the cable as you remove it from the system.
  2. Using the Phillips #1 screwdriver, remove the screw securing the intrusion switch module.
  3. Lift the intrusion switch module out of the system.
    Figure 1. Removing the intrusion switch module
    This image shows the removal of the intrusion switch module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\