CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized
in your product documentation, or as directed by the online or telephone
service and support team. Damage due to servicing that is not authorized
by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
NOTE: Certain SD cards have
a physical write-protect switch on the card. If the write-protect
switch is turned on, the SD card is not writable.
Steps
Enter System Setup, and ensure that the Internal SD Card Port is enabled.
Turn off the system, including any attached
peripherals, and disconnect the system from the electrical outlet.
Remove the system cover.
NOTE: When an SD card failure occurs, the internal dual SD module controller
notifies the system. On the next restart, the system displayed a message
indicating the failure. If redundancy is enabled at the time of SD
card failure, a critical alert will be logged and chassis health will
degrade.
Replace the failed SD card with a new SD card.
Install the system cover.
Reconnect the system to its electrical outlet
and turn on the system, including any attached peripherals.
Enter System Setup, and ensure that the Internal SD Card Port and Internal SD Card
Redundancy modes are set to the needed modes.
Verify that the correct SD slot is
set as Primary SD Card.
Check if the SD card is functioning properly.
If the Internal SD Card Redundancy option is set to Enabled at the time of the
SD card failure, the system prompts you to perform a rebuild.
NOTE: The rebuild is always sourced from the primary SD card to the secondary
SD card.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\