- Notes, cautions, and warnings
- Dell PowerEdge R530 system overview
- Documentation resources
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Options to manage the pre-operating system applications
- System Setup
- Viewing System Setup
- System Setup details
- System BIOS
- iDRAC Settings utility
- Device Settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Front bezel (optional)
- System cover
- Inside the system
- Cooling shroud
- System memory
- Hard drives
- Removing a hot swappable hard drive or SSD
- Installing a hot-swap hard drive
- Removing a 3.5-inch hard drive blank
- Installing a 3.5-inch hard drive blank
- Removing a 2.5-inch hot swappable hard drive from a 3.5-inch hard drive adapter
- Installing a 2.5-inch hot swappable hard drive into a 3.5-inch hard drive adapter
- Removing a 3.5-inch hot swappable hard drive adapter from a 3.5-inch hot swappable hard drive carrier
- Installing a 3.5-inch hard drive adapter into the 3.5-inch hot swappable hard drive carrier
- Removing a hard drive from a hard drive carrier
- Installing a hard drive into a hard drive carrier
- Optical drive (optional)
- Cooling fans
- Internal USB memory key (optional)
- Expansion cards and expansion card riser
- Expansion card installation guidelines
- Removing an expansion card from the system board
- Installing an expansion card on the system board
- Removing the optional expansion card riser
- Installing the optional expansion card riser
- Removing an expansion card from the expansion card riser
- Installing an expansion card into the expansion card riser
- iDRAC port card (optional)
- SD vFlash card (optional)
- Internal dual SD module (optional)
- Integrated storage controller card
- Processors and heat sinks
- Power supply units (PSU)
- Hot spare feature
- Removing the power supply unit blank
- Installing the power supply unit blank
- Removing an AC power supply unit
- Installing an AC power supply unit
- Non-redundant AC power supply unit (cabled)
- Wiring instructions for a DC power supply unit
- Removing a DC power supply unit
- Installing a DC power supply unit
- Power interposer board
- System battery
- Hard drive backplane
- Control panel
- System board
- Trusted Platform Module
- Troubleshooting your system
- Troubleshooting system startup failure
- Troubleshooting external connections
- Troubleshooting the video subsystem
- Troubleshooting a USB device
- Troubleshooting iDRAC Direct (USB XML configuration)
- Troubleshooting iDRAC Direct (Laptop connection)
- Troubleshooting a serial I/O device
- Troubleshooting a NIC
- Troubleshooting a wet system
- Troubleshooting a damaged system
- Troubleshooting the system battery
- Troubleshooting power supply units
- Troubleshooting cooling problems
- Troubleshooting cooling fans
- Troubleshooting system memory
- Troubleshooting an internal USB key
- Troubleshooting an SD card
- Troubleshooting an optical drive
- Troubleshooting a tape backup unit
- Troubleshooting a hard drive
- Troubleshooting a storage controller
- Troubleshooting expansion cards
- Troubleshooting processors
- System messages
- Using system diagnostics
- Jumpers and connectors
- Getting help
Dell PowerEdge R530 Owner's Manual
Cooling fans
Your system supports five cooling fans. A fan blank is pre-installed on the first cooling fan slot (FAN1).
NOTE: Hot-swap removal or
installation of the fans is not supported.
NOTE: Each fan is listed
in the systems management software, referenced by the respective fan
number. If there is a problem with a particular fan, you can easily
identify and replace the proper fan by noting the fan numbers on the
cooling fan assembly.
The following table lists the fan configuration which shows the various fan configurations based on the processor configuration in the system.
| Processor Type | CPU 1 | CPU 2 | PSU Type | FAN1 | FAN2 | FAN3 | FAN4 | FAN5 | FAN6 |
|---|---|---|---|---|---|---|---|---|---|
| 55 W-120 W | Y | N | Redundant / Cabled | N | Y | Y | Y | Y | N |
| Y | Y | Redundant / Cabled | N | Y | Y | Y | Y | Y |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\