Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R340 Installation and Service Manual

PDF

Removing the power distribution board

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the power supply units.

Steps

  1. Disconnect all the cables from the system board and the backplane.
    NOTE Observe the routing of the cable as you remove it from the system.
  2. Using a Phillips #2 screwdriver, remove the screws securing the power distribution board (PDB) to the system.
  3. Slide the PDB toward the rear of the system to disengage it from the standoffs.
  4. Lift the PDB from the system.
    Figure 1. Removing the power distribution board

    This image shows how to remove the power distribution board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\