Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R340 Installation and Service Manual

PDF

Removing the PERC card

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the expansion card riser.

Steps

  1. Remove the screw securing the blue release latch.
  2. Rotate the blue release latch to disengage it from the PERC card.
  3. Push the blue release latch until the tab on the latch clicks into the slot on the chassis.
  4. Hold the PERC card by the edges and pull it to disconnect it from the connector on the system board.
  5. Flip the PERC card and disconnect the cable from the PERC card.
    Figure 1. Removing the PERC card

    This image shows how to remove the PERC card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\