- Notes, cautions, and warnings
- About this document
- Dell EMC PowerEdge R340 system overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Front bezel
- System cover
- Air shroud
- Cooling fans
- Drives
- Removing a drive blank
- Installing the drive blank
- Removing the drive carrier
- Installing the drive carrier
- Removing the drive from the drive carrier
- Installing the drive into the drive carrier
- Removing a 2.5 inch drive from the 3.5 inch drive adapter
- Installing a 2.5 inch drive into the 3.5 inch drive adapter
- Intrusion switch
- System memory
- Expansion cards and expansion card risers
- Storage controller card
- System battery
- Optional internal USB memory key
- Optional optical drive
- Processor and heat sink
- Optional IDSDM or vFlash module
- M.2 SSD module
- Drive backplane
- Cable routing
- Power supply unit
- Power distribution board
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Dell EMC PowerEdge R340 Installation and Service Manual
Rear view of the system
- Serial port
- NIC port (GB 1)
- NIC port (GB 2)
- Half-height PCIe expansion card slot
- Full-height PCIe expansion card slot
- Power supply unit 1
- Power supply unit 2
- System identification button
- System status indicator cable port (CMA)
- USB 3.0 port (2)
- iDRAC9 dedicated network port
- VGA port
NOTE For more information about the ports and connectors, see the Dell EMC PowerEdge R340 Technical Specifications Guide.
For more information, see the Dell EMCPowerEdgeR340 Technical Specifications on the product documentation page.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\