Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R340 Installation and Service Manual

PDF

Installing the right control panel

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.

Steps

  1. Route the control panel cable through the side wall and the guide slots in the system.
    NOTE Route the cable properly to prevent the cable from being pinched or crimped.
  2. Align and insert the right control panel assembly in the slot on the system.
  3. Using the appropriate screwdriver, fasten the screws that secure the right control panel assembly.
  4. Connect the control panel cable to the connector on the system board.
    Figure 1. Installing the right control panel

    This image shows how to install the right control panel.

Next steps

  1. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\