Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R340 Installation and Service Manual

PDF

Installing the power distribution board

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. Align the slots on the power distribution board (PDB) with the standoffs on the chassis.
  2. Using a Phillips #2 screwdriver, replace the screws that secure the PDB to the chassis.
  3. Connect the cables to the system board and the drive backplane.
    NOTE Route the cables properly when you replace the PDB to prevent the cable from being pinched or crimped.
    Figure 1. Installing the power distribution board

    This image shows how to install the power distribution board.

Next steps

  1. Install the power supply units.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\