- Notes, cautions, and warnings
- Revision history
- Overview
- Updating firmware for PowerEdge MX solution
- MX7000 Solution Baselines
- Upgrading Ethernet switch using DUP
- OME-Modular licenses
- Logging in to OME-Modular
- Logging in to OME–Modular as local, Active Directory, or LDAP user
- Logging in to OME-Modular using OpenID Connect
- OME-Modular home page
- Viewing device health
- Setting up chassis
- Initial configuration
- Configuring chassis settings
- Managing chassis
- Chassis groups
- Controlling chassis power
- Backing up chassis
- Restoring chassis
- Ethernet switch backup instructions
- Exporting chassis profiles
- Managing chassis failover
- Troubleshooting in chassis
- Extracting logs
- Blinking LEDs
- Interfaces to access OME-Modular
- Viewing chassis hardware
- Viewing chassis alerts
- Viewing chassis hardware logs
- Configuring OME–Modular
- Managing compute sleds
- Managing Profiles
- Managing storage
- Managing templates
- Managing identity pools
- Ethernet IO Modules
- MX Scalable Fabric architecture
- SmartFabric Services
- Managing networks
- Managing Fibre Channel IOMs
- Managing firmware
- Monitoring alerts and logs
- Monitoring audit logs
- Use case scenarios
- Troubleshooting
- Storage
- Firmware update is failing
- Storage assignment is failing
- SAS IOM status is downgraded
- SAS IOM health is downgraded
- Drives on compute sled are not visible
- Storage configuration cannot be applied to SAS IOMs
- Drives in OpenManage are not visible
- iDRAC and OpenManage drive information do not match
- The assignment mode of storage sled is unknown
- Unable to access OME-Modular using Chassis Direct
- Troubleshooting lead chassis failure
- Storage
- Recommended slot configurations for IOMs
- Updating components in phased update order through manual orchestration
- Creating validated firmware solution baseline using Dell Repository Manager
- Upgrading networking switch using different OS10 DUP versions
- Upgrading networking switch using CLI
- CLI commands not part of chassis backup
- VMware ESXi/MX Baseline Validation Matrix
- MX7000 Solution Baselines for previous versions
- OME-Modular firmware update matrix for previous versions
Dell OpenManage Enterprise-Modular Edition Version 2.00.00 for PowerEdge MX7000 Chassis User's Guide
Configure chassis location
To configure the location of the chassis:
- Click .
The Location configuration section is expanded.
- Enter the location names for the Data Center, Room, Aisle, and Rack.The Data Center, Room, Aisle, and Rack support up to 128 characters.
- Enter the number of the Rack Slot and the name of the Location where the rack is located.The Rack Slot supports 1-255 numeric characters.
The Location supports up to 128 characters. It is supported for backward compatibility. The Data Center, Aisle, Rack, and Rack Slot properties replace this property. Use these properties to describe the physical location of the chassis.
- Click Apply to save the location settings.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\