To configure
iDRAC parameters applicable to the system, such as LAN, common IP
settings, IPv4, IPv6, Virtual Media, and LAN user configuration use
the iDRAC Settings wizard.
NOTE: You can also use the System Setup utility during startup for configuring iDRAC.
For more information about the System Setup utility, see Using The System Setup Program And Boot Manager.
In the left pane of Home page, click Hardware Configuration.
In the right pane, click Configuration Wizards.
On the System Configuration Wizards page, click iDRAC Settings, and then click
the following options to configure the different iDRAC parameters.
For more information about configuring iDRAC settings, see
the Integrated Dell Remote Access Controller (iDRAC) User’s Guide at www.dell.com/esmmanuals.
NOTE: Click System
Summary to view the parameters and their values.
Network
OS to iDRAC Pass Through
Alerts
System Event Log
Virtual Media
vFlash Media
Thermal
System Location
Front Panel Security
User Configuration
Smart Card
Lifecycle Controller
Remote Enablement
Reset iDRAC Configuration to defaults
Click Back after setting the parameters
for each option to return to the main menu.
Click Finish to apply the changes.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\