If you replaced more than one drive, make sure to populate the drives in a bottom to top order to avoid the metal stops from bending in the drive cage in the drive bays.
In the Data Manager Appliance UI:
Go to the
Infrastructure > Storage > Disks tab where you selected the disk drive to be replaced and activated the blinking LED light in
step 1d.
In the
Blinking LED light for Disk: <drive bay number>.<drive number> dialog, click
Stop to turn off the blinking LED light on the disk drive.
Click the blue
Add button.
The
Add Disk: <drive bay number>.<drive number> dialog appears.
In the dialog, click
Add.
The disk’s state will change to
Available, then to
In Use.
NOTE: It may take up to 5 minutes for a disk to appear in the Data Manager Appliance UI after it is inserted into the appliance.
On the
Alerts page, verify that there are no alerts related to the replaced drive.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\