Dell PowerProtect Data Manager Appliance 5.14.0.0 Customer Replaceable Unit (CRU) Procedures Guide for DM5500
DM5500 rear view
- Serial port
- Intel QuickAssist Technology (QAT) card (PCIe slot 2)
- Dual or quad port expansion card (PCIe slot 3)
Can be configured to run as two 25 GbE SFP28 ports, two 10 GbE SFP+ ports, or four 10GBASE-T ports
- Dual or quad port expansion card (PCIe slot 4)
Can be configured to run as two 25 GbE SFP28 ports, two 10 GbE SFP+ ports, or four 10GBASE-T ports
- SAS HBA (PCIe slot 5)
- Filler (unused) PCIe expansion card (PCIe slot 6)
- Power supply unit (PSU 1)
PSU 1 can be 1100W or 1600W, but must be the same wattage as PSU 2.
- Information tag - this contains the DM5500 serial number.
The pull-out information tag contains a white label with the 14-character DM5500 serial number. The DM5500 serial number is used as part of the default password when you log in to the PowerProtect Data Manager Appliance Configuration UI for the first time when you perform the initial DM5500 configuration.
- Power supply unit (PSU 2)
PSU 2 can be 1100W or 1600W, but must be the same wattage as PSU 1.
- LAN on motherboard (LOM) ethernet port (2) (PCIe slot 1)
Can be configured to run as two 25 GbE SFP28 ports, two 10 GbE SFP+ ports, or two 10GBASE-T ports
- Ethernet port (2)
Gb1 and Gb2 service ports used for initial DM5500 login. Only one of these ports at a time can be used for the initial DM5500 login.
- USB 3.0 port (2)
- iDRAC9 dedicated network port
- VGA port
- System identification button
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\