Dell PowerProtect Data Manager Appliance 5.16.0.0 Installation Guide for DM5500

Installing the chassis retention brackets

Prerequisites

You must install the chassis retention bracket on the two rear rack flanges before you install the DM5500 into the rack.

1. Cage nut (2)
2. Screws (2)
3. Chassis retention bracket

NOTE:The chassis shown in the image is not representative of a specific system.

To install each chassis retention bracket, perform the following steps.

1. Place the bracket on the system.
2. Secure the bracket to the rack flange with two screws by using Phillips #2 screwdriver.
   The installed chassis bracket on each rack flange should look like the following image.

   NOTE: Do not overtighten the retention brackets; keeping them slightly loose will make it easier to insert the system under them when positioning the system on the rails.