- Notes, cautions, and warnings
- Preface
- Overview
- Install the DM5500 in the rack
- DM5500 cabling and network requirements
- Install the expansion enclosure in the rack
- Expansion enclosure cabling requirements
- Pre-configuration tasks
- Configure the DM5500 in the Data Manager Appliance Configuration UI
- Set the passphrase for the DM5500
- Troubleshooting
Dell PowerProtect Data Manager Appliance 5.16.0.0 Installation Guide for DM5500
Installing rails onto the rack
Steps
- Identify the rack holes to use for installing the rails in the racks.
- Press the latch on the rear rail bracket and insert the rail into the rack post. Release the latch to lock the rail in place.
Figure 1. Connecting the rail to the back post 
- Extend the rail to fit between the front and rear rack posts.
- Insert the pins on the front of the rail into the rack holes of the front rack post.
Figure 2. Attaching the rail to the front post 
- Secure the front rail bracket with one screw.
- Secure the rear rail bracket with two screws.
Figure 3. Securing the rails to the rack 
- Repeat these steps for the second rail.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\