In the
Network Name field, type the name of the new virtual network.
It is recommended that you keep the network names consistent for each VLAN.
In the
VLAN ID field, type the numeric value 2 through 4094 that corresponds to the VLAN which this virtual network represents.
NOTE:Access mode is not supported for the backup network.
From the
Uplink Group drop-down, select the
Uplink Group name.
By default, the applicable
MTU (maximum transmission unit) value for the virtual network is displayed along with the
Uplink Group.
Allowable
MTU value is 1500.
In the
Subnet Mask field, type the applicable subnet mask address.
For the
Data IP Addresses field, provide the indicated number of reserved IP addresses for
PowerProtect Data Manager Appliance to use for communication on this virtual network.
To add values to the pool, type an IP address in the field provided. To add an additional IP address click on the
+ button and type in the IP address. To remove additional IP address from the pool, click the
Delete icon next to the additional IP address field.
NOTE:A maximum of three IP addresses can be configured for Static IP Addresses when selecting all traffic types.
NOTE:A maximum of two IP addresses can be configured for Static IP Addresses without Cloud DR.
NOTE:Maximum one IP address can be configured for Static IP Addresses for Cloud DR.
Verify that the static IP address pool contains enough addresses to add the virtual network.
Click
Next.
The
Add Network wizard moves to the
Routes window.
Click
Next.
The
Add Network wizard moves to the
Summary page.
Verify the configuration information, and then click
Apply.
The
Add Network wizard closes and the
Networks window appears.
Click
Uplinks.
The
Uplinks window appears , and the
Network Count
of the Uplink Group appears as
1.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\