Review the following additional considerations for
encryption in-flight.
To validate that encryption is in use, you can check the status of existing connections on the
DD system by running the
ddboost show connections command in the
DD Boost CLI:
If a connection was established with encryption, the value in the
Encrypted column is
Yes.
If a client establishes a connection with encryption, and establishes another connection without encryption, the value in the
Encrypted column is
Mixed. This circumstance might occur for one of the following reasons:
Encryption settings that are defined on a per-client basis remain in place for a while after the client has disconnected. If the client previously established a connection without encryption and then later established a connection with encryption, the value shows as
Mixed.
Encryption settings are not specified for the DD Boost connections that are created on the application agent. The individual agent user guides provide more information.
If encryption settings exist on the
DD and are also enabled in
PowerProtect Data Manager Appliance, the higher setting takes precedence. As a result, the
Encrypted column always shows
Mixed or
Yes.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\