PowerProtect Data Manager Appliance new deployment overview
Familiarize yourself with the high-level steps required to deploy
PowerProtect Data Manager Appliance with the application agent.
Steps
Design how to group the backups, based on the storage requirements and retention policies.
The account team can help with backup storage design.
Install the application agent on the appropriate hosts and connect them to
PowerProtect Data Manager Appliance according to the instructions in the next chapter.
DBAs should perform this operation.
NOTE:After you create a centralized protection job, the first backup is a full backup.
Add new or approve pending agent requests in the
PowerProtect Data Manager Appliance according to the instructions in the next chapter.
Add a protection policy for groups of assets that you want to back up.
The
PowerProtect Data Manager Appliance Administrator Guide provides instructions.
Configuration is complete.
Perform a full backup so that
PowerProtect Data Manager Appliance can detect the proper backup chain.
Without a full backup,
PowerProtect Data Manager Appliance treats the backups as partial and assumes that you are out of compliance. DBAs create backups and
PowerProtect Data Manager Appliance creates a catalog of the backups, monitoring the catalog for retention policy compliance, and, if configured, managing the life cycle of the backups.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\