Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Dell PowerProtect Data Manager Appliance 5.15.0.0 Installation Guide for DM5500

Removing power supply units

Prerequisites

Before you install the DM5500 into the rack, you must remove all drives and power supply units from the DM5500 due to the weight of the system.

CAUTION:The DM5500 supports either 1100W PSUs or 1600W power supply units, depending on the country or region where it is installed. When you are replacing a power supply unit, make sure that both power supply units are the same wattage.

Steps

Press the release latch and slide the power supply unit out of the system by using the power supply unit handle.
Figure 1. Removing a power supply unit
This image shows how to remove a power supply unit.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\