- Notes, cautions, and warnings
- Preface
- Overview
- Install the DM5500 in the rack
- DM5500 cabling and network requirements
- Install the expansion enclosure in the rack
- Expansion enclosure cabling requirements
- Pre-configuration tasks
- Configure the DM5500 in the Data Manager Appliance Configuration UI
- Set the passphrase for the DM5500
- Troubleshooting
Dell PowerProtect Data Manager Appliance 5.15.0.0 Installation Guide for DM5500
Installing power supply units
Prerequisites
CAUTION:Ensure that both the PSUs are of the same type and have the same maximum output power.
The maximum output power (shown in watts) is listed on the power supply unit label.
Steps
Slide the power supply unit into the power supply unit bay until the power supply unit is fully seated and the release latch snaps into place.
Figure 1. Installing a power supply unit 
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\