- Notes, cautions, and warnings
- Preface
- Overview
- Install the DM5500 in the rack
- DM5500 cabling and network requirements
- Install the expansion enclosure in the rack
- Expansion enclosure cabling requirements
- Pre-configuration tasks
- Configure the DM5500 in the Data Manager Appliance Configuration UI
- Set the passphrase for the DM5500
- Troubleshooting
Dell PowerProtect Data Manager Appliance 5.15.0.0 Installation Guide for DM5500
Closing the drive bays
Steps
- Pull back the blue release tabs on both sides and slide the drive bays into the system, until both the bays lock into place.
Figure 1. Closing drive bays 
- If required, lock the drive bay lock located above left release latch, by pushing it down.
Next steps
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\