CAUTION:The DM5500 server needs one power supply unit (PSU) for normal operation. On power-redundant systems, remove and replace only one PSU at a time in a DM5500 server that is powered on. The DM5500 supports either 1100W PSUs or 1600W PSUs, depending on the country or region where it is installed. When you are replacing a PSU, make sure that both PSUs are the same wattage.
Steps
Press the release latch and slide the PSU out of the system by using the PSU handle.
Figure 1. Removing the power supply unit
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\