- Notes, cautions, and warnings
- Preface
- Prepare for hardware replacement
- DM5500 customer replaceable unit procedures
- Expansion enclosure customer replaceable unit procedures
Dell PowerProtect Data Manager Appliance 5.15.0.0 Customer Replaceable Unit (CRU) Procedures Guide for DM5500
Installing the power supply unit
About this task
Ensure that both the PSUs are of the same type and have the same maximum output power.
NOTE:The maximum output power (shown in watts) is listed on the PSU label.
Steps
Slide the PSU into the PSU bay until the PSU is fully seated and the release latch snaps into place.
Figure 1. Installing the power supply unit 
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\