- Notes, cautions, and warnings
- Preface
- Prepare for hardware replacement
- DM5500 customer replaceable unit procedures
- Expansion enclosure customer replaceable unit procedures
Dell PowerProtect Data Manager Appliance 5.15.0.0 Customer Replaceable Unit (CRU) Procedures Guide for DM5500
Closing the drive bays
Steps
- Pull back the blue release tabs on both sides and slide the drive bays into the system, until both the bays lock into place.
Figure 1. Closing drive bays 
- If required, lock the drive bay lock that is located above left release latch, by pushing it down.
NOTE:In some circumstances, the drive bays may not close after fully opening, due to the sheet metal on the rail bracket being bent and blocking the rail stop. To fix the issue, use a plastic scribe to pry the sheet metal back to its default position and try closing the drive bays.
Figure 2. Fixing the rail bracket bending issue 
Next steps
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\