Configure Replication in Disaster Configuration Page
This procedure shows how to configure replication in the Disaster Configuration page.
Steps
- Click , select Disaster Recovery, and then click Configuration.
- To enable server DR replication:
NOTE:If the source storage unit has compliance mode retention locking enabled, you must provide the username and password for the security officer who is associated with the source and destination protection storage systems.
- Check Enable Replication.
- From the
Replicate Backup To drop-down list, select a target from the list of existing
protection storage systems.
The replication target cannot be the backup destination.
- Click
Save.
NOTE:In System Jobs, if replication has not synced within three hours, a warning is displayed and if the replication has not synced within six hours, the activity is marked as failed.In System Jobs, wait for the replication target auto-configuration job to succeed and in the Replication Targets tab, select the external DD and click More Actions > Manage Storage Units and verify if the replication target storage unit is visible.