Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge XR8620t Installation and Service Manual

PDF

Removing the expansion card riser 1

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud
  4. Remove the M.2 direct riser
  5. Remove the side cover .
  6. Disconnect the riser card power cables from 2U PDB and 4x signal cables from connectors on the system board.
    NOTE:Observe the routing of the cable as you remove it from the system.

Steps

  1. Using the Phillips 2 screwdriver, loosen the captive screws that secure the riser 1 on the 2U sled.
  2. Hold the expansion card riser 1 by the edges and lift the expansion card riser from the riser connector on the 2U sled.
    Figure 1. Removing the expansion card riser 1

    This image shows removing Riser 1

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\