- Notes, cautions, and warnings
- About this document
- Dell PowerEdge XR8620t system configurations and features
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Minimum configuration to POST
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- XR8000r chassis
- Sled cover
- Air shroud
- M.2 direct riser module
- ROR N1 module
- 2U sled
- Storage interposer module
- Cooling fans
- Expansion cards and expansion card risers
- BOSS-N1 card
- Power distribution board
- Cable routing
- System memory
- Processor and heat sink module
- System battery
- System board
- Trusted Platform Module
- Jumpers and connectors
- Using system diagnostics
- Getting help
- Documentation resources
Dell PowerEdge XR8620t Installation and Service Manual
Removing the sled cover
Prerequisites
- Follow the safety guidelines listed in the Safety instructions.
- Power off the sled, and any attached peripherals.
- Follow the steps for Removing a sled.
- Place the sled on the flat surface with the top cover facing upwards.
Steps
- Press the latch and slide the cover toward the front of the server until it reaches the unlock position.
- Lift the cover from the sled.
Figure 1. Removing the sled cover 
Next steps
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\