Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge XR8620t Installation and Service Manual

PDF

Removing the 2U top sled from the 2U node

Prerequisites

  1. Follow the safety guidelines listed in Safety Instructions.
  2. Follow the procedure listed in Before working inside your system
  3. Remove the sled cover.
  4. Remove the air shroud.
  5. Remove the M.2 direct riser
  6. Remove the side cover
  7. Remove the Riser1 4x signal cables from connectors on the system board
  8. Remove the sideband cables between the 1U and 2U PDBs

Steps

  1. Using Phillips 1 screwdriver, remove the side screws and loosen the front captive screw that secure the 2U top sled from the 2U node.
  2. Using both hands, slide forward and lift the 2U top sled from the 2U node.
    Figure 1. Removing the 2U top sled from the 2U node

    This image shows removing the 2U top sled from the 2U node

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\