Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Dell PowerEdge XR8620t Installation and Service Manual

Removing the expansion card riser 2

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the 2U top sled from the 2U node.

Steps

  1. Using the Phillips 2 screwdriver, loosen the captive screw that secure the riser 2 on the 1U node.
  2. Hold the expansion card riser 2 by the edges and lift the expansion card riser from the riser connector on the 1U node.
    Figure 1. Removing the expansion card riser 2

    This image shows removing the Riser 2


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\